Product category:
Floors
News Release from: Schluter-Systems | Subject: Tiling onto Acoustic Floors
Edited by the Buildingtalk Editorial
Team on 13 April 2005
The Sound of Success
Can tiles can be successfully installed onto acoustic floors? Ian Knifton, Schluter's Technical Manager, gives an overview.
Schluter-Systems is frequently asked if tiles can be successfully installed onto acoustic floors Unfortunately, there is no definitive answer
This article was originally published on Buildingtalk on 11 Apr 2008 at 8.00am (UK)
Related stories
Ceramic Tile Distributors new Glasgow showroom
Showroom floor was tiled with Vitra 440 x 440 Cemento Mink and a number of Schluter profiles were specified to ensure the installation's long-lasting integrity.
Award-winning underfloor heating system
John Croft has installed Schluter-Bekotec-therm under all 1,470 square metres of flooring at his luxury eco-house in the Cotswolds.
Ian Knifton, Schluter's Technical Manager, says that with appropriate tiling protection some acoustic floors will accommodate tiles, but others won't.
Question.
I've been asked by a customer to tile onto an acoustic floor.
Further reading
Penthouse owner shows sound taste
Tiling contractors Maurice Parker installing the acoustic membrane Schluter-DITRA-SOUND to cut the impact sound perception by more than half.
Single room pack fast-tracks underfloor heating
Two special versions of Schluter-Systems' award-winning underfloor heating system have been developed for small extensions and conservatories.
How can I decide whether it's suitable to take tiles or not?.
Answer.
Installers should always seek specific advice relating to the individual application.
There is now a wide variety of acoustic flooring available, mainly to come into line with Building Regulations for sound and heat insulation -- some of which is suitable to tile onto with the proper materials, but some is totally unsuitable, especially where there is rigidity and stability.
To put a rigid finish, such as tiles, over a surface that is very compressible, is asking for trouble: the grout lines would crack first, then the tiles would crack at the joints, and finally debond.
Question.
What sort of installations would be suitable for tiling onto, with "appropriate tiling protection"? A At the request of installers, Schluter has carried out a number of site inspections where some acoustic flooring would take tiles with the correct protection: for instance, a chipboard floor with felt bonded to its underside acting as the acoustic barrier, batons with different types of foam, and others with acoustic matting.
Question.
How can the tiles be protected in these cases?.
Answer.
With all these it would be possible to protect the tiles with a specialist uncoupling membrane, which allows any stresses that occur between the acoustic flooring and the tiles to be neutralised evenly.
Question.
How is it installed?.
Answer.
In a nutshell, after ensuring that the substrate is even and load-bearing, the bonding adhesive is applied with a 3mm x 3mm notched trowel.
While the type of bonding adhesive depends on the type of substrate, for most substrates a dry-set tile adhesive is suitable.
The fleece on the underside of the membrane needs to be solidly embedded into the adhesive so that its entire surface is bonded.
Work the membrane into the adhesive, in just one direction, using a float or screed trowel.
The tiles can be laid on top immediately afterwards, by anchoring the adhesive into the square cavities.
The fleece is adhered to the substrate with standard adhesive.
And the adhesive used to bond the tiles actually anchors into the dovetailed configuration, mechanically locking the tiles onto the top.
Any stresses that then occur between the substrate ands the tiles are evenly distributed in all directions, protecting the tiles from damage.
However, if the flooring is too compressible, the movement under the rigid tiled surface will be too much even for the uncoupling membrane to absorb.
That's why installers should always seek specific advice about each particular application. Request a free brochure from Schluter-Systems ...
• Schluter-Systems: contact details and other news
• Email this article to a colleague
• Register for the free Buildingtalk email newsletter
• Buildingtalk Home Page
Search the Pro-Talk network of sites
