Newton’s product portfolio is expanding once again, now including a comprehensive range of injection resins, suitable for the remedial repair of cracks in concrete that can lead to water ingress.
Injection resins are suitable for application in basements, underground parking, tunnel projects, wall/floor transitions, concrete slabs, bridges, construction sites and lift pits.
Mechanical, chemical and climatic loads can create stresses in concrete, as the tensile load that concrete can withstand is only between 2 – 10% of its compressive strength.
There are many ways in which cracks in concrete can be caused, such as incorrect design calculations, unforeseen loads, incorrect steel placement, shrinkage and excess heat generation.
Newton’s new range of injection resins offer a remedial repair solution, as they can be utilised to close cracks and voids to prevent any substance penetration, to seal from any leaks, to flexibly seal across crack flanks and to reinstate structural integrity between the sides of cracks and voids.
Five different injection resins have been added to the Newton product portfolio, as part of the Newton ReSeal System alongside injection hoses, packers and cleaners, which are required for both injecting and cleaning up after resin injection projects.
Newton’s injection resin range is available now for projects with the necessary requirements and has been specified on several projects already.
Newton Specialist Contractor ASF Waterproofing, have utilised Newton 320-FP and 322-SP at a new-build development on Blackfriars Road in Southwark and Newton 324-SR at a new-build shopping centre in Shepherd’s Bush, West London.
For any further information and to download all product literature, please visit the product pages of each Newton Injection Resin, or alternatively contact Newton’s Technical department on 01732 360 095 or [email protected]
Newton Waterproofing Systems,
17-20 Sovereign Way,
Phone: 01732 360 095
Fax: 01732 359 033
E-mail: [email protected]
Kaz Spiewakowski and Timothy Perry have been appointed to the Guild of Architectural Ironmongers’ (GAI) executive committee.Posted in Architectural Ironmongery, Articles, Building Associations & Institutes, Building Industry News, Building Products & Structures, Doors, Recruitment
London-based architect, WHAT_Architecture has specified CUPA PIZARRAS’ CUPACLAD 101 Logic as the ideal rainscreen cladding system for a new and unusual housing block in Peckham.Posted in Articles, Building Industry News, Building Products & Structures, Case Studies, Cladding, Restoration & Refurbishment, Retrofit & Renovation, Roofs, Walls
The Builders Merchants Building Index (BMBI) report, published in October, shows builders’ merchants’ sales to builders and contractors continuing to recover in August, but at a slower pace compared to the previous two months.Posted in Articles, Building Associations & Institutes, Building Industry News, Building Products & Structures, Building Services, Civil Engineering, Landscaping, news, Research & Materials Testing
EJOT has secured ETA (European Technical Assessment) approval for its Iso-Corner load-bearing bracket.Posted in Articles, Building Industry News, Building Products & Structures, Building Regulations & Accreditations, Facades, Insulation, Posts, Retrofit & Renovation, Walls