Up to a third of the UK’s greenhouse emissions come from central heating, according to some estimates.
The National Infrastructure Commission (NIC), which advises the government on infrastructure policy, has said ‘the UK cannot achieve its emissions targets while relying on natural gas, a fossil fuel, for heating.’
Its new ‘NET ZERO Commission recommendations and the net zero target’ report said: “The increased volume of new heating systems that will need to be installed mean taking steps to trial heat pumps and hydrogen heating is even more urgent.
“Energy efficiency measures should be installed in the short term to reduce emissions from heat. Whichever approach the government chooses to take to decarbonise heat, energy efficiency measures will be needed to reduce energy demand from heat.
“Energy efficiency measures will be particularly important if heat is electrified, as heat pumps work best in buildings with reasonably high insulation standards as they provide constant, but low level, heat.”
Renewables and conservation of resources have long been top of the agenda. From householder to construction industry focused water use efficiency campaigns, encouragements to make use of leak detection and water use monitoring gadgetry and pushes to use renewable building materials, but a dramatic change to central heating systems is likely to soon be forced to the top of the agenda.
Heat pumps and hydrogen heating may become a big part of construction of the future.
Heat pumps extract heat from the ground, air or a body of water and transfer it elsewhere, such as a home’s heating system.
Ground source heat pumps rely on a network of pipes laid in the ground to extract the heat while air source pumps use fans.
An accessible appropriate body of water is required to enable a water pump system.
Ground pumps circulate water and antifreeze around a pipe system, laid either vertically or horizontally, in the land next to a building. A compressor is then used to raise the temperature of the fluid and circulate it around a building.
Due to the fact that below surface ground stays at a fairly constant temperature, heat is available year-round. Ground pumps can service heating and hot water requirements.
Vertical bore holes for a ground source system typically need to be around 90 metres to 160 metres deep, according to the Energy Saving Trust. While the space needed for a horizontal loop depends on localised factors, it says.
Air pumps rely on electricity to operate but the renewable energy generated is greater than the amount of electricity required.
In the UK, air-to-water systems are most common. They transfer the heat from the air into water which can be circulated around a home in the wet central heating system.
As heat pumps work at lower temperatures than standard boilers they are more suited to systems that emit heat at lower temperatures over longer periods, such as underfloor heating.
A hot water tank is required and homes must be well insulated.
As far back as 2013, Bennett Homes incorporated air-to-water pumps in a 22-unit housing development in Attleborough, Norfolk.
More recently, also in Norfolk, air source heat pumps have been included in a Crabtree Living 10-home development in Strumpshaw.
Authors of the Transitioning to Hydrogen report concluded that our natural gas networks could be repurposed for hydrogen gas, which is abundantly available, in water, for example.
For consumers it would mean little discernible difference to what they are used to as gas appliances and boilers could be converted. In the 1960s and 70s a conversion took place in the UK from the use of town gas (which was mostly produced from coal and oil) to natural gas.
Earlier this year, Worcester Bosch revealed a prototype of a boiler that could be converted from operating with natural gas to hydrogen.
Gilberts is enabling data centre architects and constructors to face the challenge of delivering a sustainable ventilation strategy.
Posted in Air Conditioning, Articles, Building Industry News, Building Products & Structures, Building Services, Facades, Facility Management & Building Services, Heating, Ventilation and Air Conditioning - HVAC, Information Technology, Restoration & Refurbishment, Retrofit & Renovation, Sustainability & Energy Efficiency, WallsThe Delta Pumps and Basement Drainage Distribution Hub is home to Delta’s in-house fabrication team.
Posted in Articles, Building Industry News, Building Products & Structures, Building Services, Damp & Waterproofing, Drainage, Drainage Services, Drainage, Guttering, Soffits & Fascias, Facility Management & Building Services, Membranes, Pipes, Pipes & Fittings, Plumbing, Research & Materials Testing, Restoration & Refurbishment, Retrofit & Renovation, WallsVortice, a leading manufacturer of ventilation solutions, proudly announces the launch of its newest addition to the Punto Filo domestic fan range: the sleek 4” black bathroom fan.
Posted in Air Conditioning, Articles, Bathrooms, Bedrooms & Washrooms, Building Industry News, Building Products & Structures, Building Services, Facility Management & Building Services, Heating, Ventilation and Air Conditioning - HVAC, Innovations & New Products, Interiors, Restoration & Refurbishment, Retrofit & RenovationPower tool manufacturer Makita has added a new battery powered wheelbarrow to its extensive LXT outdoor power equipment range.
Posted in Articles, Building Industry News, Building Products & Structures, Garden, Hand Tools, Innovations & New Products, Plant, Equipment and Hire, Power Tools, Restoration & Refurbishment, Retrofit & Renovation, Site Preparation